Air Cleaner Gaskets & Hardware

Frequently Asked Questions

Replace the gasket if it is torn, hardened, crushed unevenly, contaminated, or no longer seals cleanly when the air cleaner goes back on. Reusing a damaged gasket can leave an unwanted gap at the mounting surface. If the existing gasket is still in good condition and the manufacturer allows reuse, it may not need replacement every time the lid or filter element is serviced.

Match the thread size at every connection and make sure the installed length works with the full air-cleaner stack. A stud that threads into the carburetor can still be wrong if it is too short for the filter and lid or so tall that it creates hood-clearance problems. Adapters can also change between thread sizes, so check both ends rather than ordering by appearance.

No. “Universal” does not mean every carburetor, throttle body, lid, or center nut uses the same thread or required length. Verify the carburetor-side thread, the air-cleaner hardware, the installed height, and available hood clearance. If an adapter is needed, use the correct thread conversion instead of forcing mismatched hardware.